Mario Kart Wii battery case - Need to change the batteries? Slide and lift the kart body to access the battery cover on the motor.Parts List error - 2 Goombas (brown pieces with angry faces) pictured in Parts List are not included in the build and the pieces are not included as part of the set.Īdditional Tips to help get your motors functioning properly:.Specific Building Help for Bowsers Castle Ultimate Building Set #38437 Motor switch - If you have difficulty moving the switch to the ON position, turn the rear wheels and try the switch again.During heavy continuous play, or if motor/batteries feel very warm, allow the Karts/Batteries a 5 minute rest (turning motor off) to allow batteries to cool and recover.Kart Speed - Drop in Kart speed may be noticed after 15 - 20 minutes of continuous play, if this happens turn motor off and allow to rest for 5+ minutes in order for batteries to re-energize.Battery case - To access the batteries in your Kart, unscrew the cover and slide it back about ¼ inch before lifting up to remove the cover.
Batteries - Karts with fresh batteries tend to run tend to run at their maximum speed and may sometimes run off the track.Center the Kart shell over the motor and press down then slide back until you feel it snap into place. Kart shells - The colorful Kart shell (body) should snap into place on the motor with clearance for the wheels to turn.If you are having difficulty, try turning the motor on its side to attach the hub - remember to press firmly. Be sure you have firmly pushed the hub onto the axle so you feel a snap. Hubs - The hubs are "snap" fit into place on the hubs and the fit is firm.Karts may spin out frequently - clean rear tires with sticky tape. The soft rubber tires need to be on the back wheels of the car this allows the karts to gain traction on the track. Tires - If your karts are spinning on the track or not moving - check the placement of the black tires.